Skip to content

Instantly share code, notes, and snippets.

@youngjuning

youngjuning/config.txt

Created November 22, 2018 01:45
Show Gist options

  • Select an option

    Learn more about clone URLs
  • Save youngjuning/e859fa9eb13bebd9da422bfd78e213e0 to your computer and use it in GitHub Desktop.

Select an option

Learn more about clone URLs
Save youngjuning/e859fa9eb13bebd9da422bfd78e213e0 to your computer and use it in GitHub Desktop.
Download ZIP

Revisions

  1. youngjuning created this gist Nov 22, 2018.
    58 changes: 58 additions & 0 deletions config.txt
    View file
    Original file line number Diff line number Diff line change
    @@ -0,0 +1,58 @@
    # For more options and information see
    # http://rpf.io/configtxt
    # Some settings may impact device functionality. See link above for details

    # uncomment if you get no picture on HDMI for a default "safe" mode
    #hdmi_safe=1

    # uncomment this if your display has a black border of unused pixels visible
    # and your display can output without overscan
    #disable_overscan=1

    # uncomment the following to adjust overscan. Use positive numbers if console
    # goes off screen, and negative if there is too much border
    #overscan_left=16
    #overscan_right=16
    #overscan_top=16
    #overscan_bottom=16

    # uncomment to force a console size. By default it will be display's size minus
    # overscan.
    #framebuffer_width=912
    #framebuffer_height=492

    # uncomment if hdmi display is not detected and composite is being output
    #hdmi_force_hotplug=1

    # uncomment to force a specific HDMI mode (this will force 1080p)
    hdmi_group=2 # DMT分辨率
    hdmi_mode=82 # 1080p
    hdmi_ignore_edid=0xa5000080 # 不检测HDMI设备的任何信息

    # uncomment to force a HDMI mode rather than DVI. This can make audio work in
    # DMT (computer monitor) modes
    #hdmi_drive=2

    # uncomment to increase signal to HDMI, if you have interference, blanking, or
    # no display
    #config_hdmi_boost=4

    # uncomment for composite PAL
    #sdtv_mode=2

    #uncomment to overclock the arm. 700 MHz is the default.
    #arm_freq=800

    # Uncomment some or all of these to enable the optional hardware interfaces
    #dtparam=i2c_arm=on
    #dtparam=i2s=on
    #dtparam=spi=on

    # Uncomment this to enable the lirc-rpi module
    #dtoverlay=lirc-rpi

    # Additional overlays and parameters are documented /boot/overlays/README

    # Enable audio (loads snd_bcm2835)
    dtparam=audio=on
    #scaling_kernel=8