| # This file came from https://github.com/Klipper3d/klipper/blob/master/config/generic-creality-v4.2.7.cfg | |
| # This file contains pin mappings for the Creality "v4.2.7" board. To | |
| # use this config, during "make menuconfig" select the STM32F103 with | |
| # a "28KiB bootloader" and serial (on USART1 PA10/PA9) communication. | |
| # Flash this firmware by copying "out/klipper.bin" to a SD card and | |
| # turning on the printer with the card inserted. The firmware | |
| # filename must end in ".bin" and must not match the last filename | |
| # that was flashed. |
| # Automation to publish sensor data to MQTT | |
| - id: publish_epaper_sensors | |
| alias: Publish epaper sensors | |
| initial_state: true | |
| mode: parallel | |
| max: 50 | |
| trigger: | |
| - platform: state | |
| entity_id: input_boolean.waveshare_ota_mode | |
| - platform: state |
This page has been updated a lot in the past 3 years. Older revisions you might like more than this one: